FMCW radar basics: how a mmWave radar measures range, speed and angle
An introduction to the frequency-modulated continuous-wave (FMCW) principle used by most automotive and industrial mmWave radars.

Most mmWave radars in cars, buildings and factories use frequency-modulated continuous wave (FMCW) operation. The transmitter sends a chirp, a signal whose frequency rises linearly over time, and the receiver mixes the echo with the signal being transmitted at that moment.
Range
An echo from a target at distance R arrives after a delay of 2R/c. Because the transmitted frequency keeps rising, the echo and the current transmit signal differ by a constant frequency, the beat frequency, which is proportional to the distance. A Fourier transform (the range FFT) of the mixed signal turns each target into a peak at its range.
Range resolution depends only on the chirp bandwidth B: ΔR = c / 2B. A 4 GHz chirp in the 77–81 GHz band resolves targets about 3.75 cm apart.
Velocity
A moving target changes its distance slightly from one chirp to the next. This shows up as a phase shift of its range peak across consecutive chirps. A second FFT across the chirps of one frame (the Doppler FFT) measures that phase rotation and gives the radial velocity of each target.
Angle
With several receive antennas, an echo reaches each antenna with a slightly different phase that depends on its direction of arrival. A third FFT or a beamforming step across the antenna array estimates the angle. More virtual channels, formed by combining transmit and receive antennas (MIMO), give finer angular resolution.
Typical processing chain
- ADC sampling of the mixed (IF) signal for each chirp
- Range FFT per chirp
- Doppler FFT across chirps
- Detection, for example CFAR, on the range-Doppler map
- Angle estimation for detected points, then clustering and tracking
This article is a placeholder for the Andar technical blog. Articles on radar design, applications and engineering practice will follow.